Zhangjiagang Shenzhou Machinery Co.,Ltd
Call us on:+86-512-58428808   E-mail: cch@shenzhoumac.com
Home > News > Content
Testing For Injection Molding Machine And 10L 15L Plastic Bucket Cap Mould

Inspection process


A: Appearance inspection

• Inspect mechanical

• Electronic components

• Lubricating device

• Hydraulic valve

• Chiller


Check whether all of them are in good condition .


B:Electrify inspection

1Connecting electricity to injection molding machine ,then check the computer control panel pressure gaugebarrel heater  and other components, Check whether all of them are in good condition.


2 Check whether the mould and chiller  are in good condition with injection molding machine to produce the plastic caps.Start to do the mold trail.



C: Cap inspection :

• Compare the caps with drawing after getting all the testing samples, mark clearly if anything different from each other.


• Check whether the cap match the bottle, elastic degrees and aesthetic measure.


•  water test

Product Categories

Fast Track

  • Feedback
    Zhangjiagang Shenzhou Machinery Co.,Ltd welcomes your comments! Please fill this form to give us feedback or report any problem when experiencing our website.
  • Quick Navigation
  • Contact Us
    Address: No.22, Zhenbei Road, Xizhang, Fenghuang Town, Zhangjiagang City, P.R. China
    Tel: +86-512-58428808    
    Fax: +86-512-58457018    
    E-mail: cch@shenzhoumac.com
Copyright © Zhangjiagang Shenzhou Machinery Co.,Ltd